| Instructor's Guide - CD-ROM Answers: Course 4 Lesson 5 | Click to Return | ||||||||||||||||
|
Number |
CD-ROM Question | Answer |
|
Type |
|||||||||||||
|
|
|||||||||||||||||
| 3 | When would all of the tool offsets need to be re-entered during the setup of a new job? Click on each correct answer. | Whenever the Large Offsets Method is used, all tool offsets must be found and entered each time a new job is setup. | 19 |
|
|||||||||||||
|
|
|||||||||||||||||
| 4 | A Setup Piece is mounted in the chuck. What value would be entered to allow calculation of the X axis offset when this tool is being touched-off? Enter the correct value on the keypad. | The computer calculates the tool offset by entering the diameter value of the workpiece. | 24 |
|
|||||||||||||
|
|
|||||||||||||||||
| 5 | What value would be entered to allow the calculation of the Z axis offset when this tool is being touched-off? Enter the correct value on the keypad. | Since Program Zero is on the back of this piece, the part length must be entered to correctly calculate the Z offset. | 25 |
|
|||||||||||||
|
|
|||||||||||||||||
| 6 | What value would be entered to allow the calculation of the Z axis offset when this tool is being touched-off on the Setup Piece? Enter the correct value on the keypad. | Since Program Zero is on the face of the Setup Piece, a zero is entered. | 26 |
|
|||||||||||||
|
|
|||||||||||||||||
| 7 | In what order are these steps performed when entering an X axis tool offset when the control calculates the offset? Click on each step in the correct sequence. | The order in which these tasks should be performed is indicated. 4,2,5,1,6,3 | 32 |
|
|||||||||||||